Stiebel Point of Use Tankless Water Heater

The Stiebel Eltron DHC 10-2 Electric Water Heater is designed for installation at the point of use. They heat water instantaneously as it flows through the unit. Stand-by losses are completely eliminated. The heating elements are controlled by a flow switch and by an exclusive scald-guard thermostat, which keeps the water temperature within safe limits at all times. In addition, the DHC water heaters are equipped with a safety high-limit with manual reset. The rugged all copper design ensures many years of reliable service.The DHC 10-2 Electric Water Heater is shipped with 0.5 GPM pressure compensating flow reducer/aerators that fit on most faucets. Flow controls and faucet aerators are highly recommended in conjunction with tankless water heaters.Stiebel Eltron DHC 10-2 Electric Water Heater Features: Up to 50% less electric consumption compared to storage type heaters, hot water instantly, with exclusive built-in scald guard thermostat, fits anywhere due to its lower installation cost in comparison to storage type water heaters.Requires 1 independent 240V AC circuit protected by 1 separate and independent 40 amp double pole breaker. Minimum recommended electrical service is 50 amps.Other Features Include:No scalding: electronic control system does not allow the water temperature to go above 125º FSimple design of plumbing system: no need for a T & P valve, drain or mixing valveHeating Capacity:80º F Rise at 0.8 gpm70º F Rise at 0.9 gpm60º F Rise at 1.1 Gpm50º F Rise at 1.3 gpm40º F Rise at 1.6 gpm